Skip to main content

Music Production

Noise Gate

Definition

A noise gate is an audio processor that turns a signal down or off whenever its level falls below a set threshold, silencing hiss, hum or spill in the gaps between the notes and phrases you want to keep.

A recording is rarely silent between the notes. A guitar amplifier hums, and the tom microphones on a drum kit hear the snare and cymbals. A noise gate works like a door. When the signal is louder than a level you choose, the door opens and the sound passes; when it falls below that level, the door closes and the signal is turned down or off.

A gate cannot remove noise that sounds at the same time as the music. It only cleans up the gaps, so it works best on parts with clear pauses.

The controls

  • Threshold: the level that opens the gate. Set it above the noise but below the quietest note you want to keep.
  • Attack: how quickly the gate opens. Fast suits drums; a slower attack avoids a click on sounds that begin gently.
  • Hold: the minimum time the gate stays open once it has opened, before it starts to close.
  • Release: how quickly it closes. Match it to the natural decay of the sound, or the end of every note is chopped off.
  • Range (also labeled floor or reduction): how far the signal is turned down when the gate is closed. Full muting can make the background vanish and return noticeably; a few decibels of reduction often sounds more natural.
  • Hysteresis (called return on some gates): a second, lower closing threshold, so the signal must fall a few decibels further before the gate closes again.

A level hovering around the threshold can make a fast gate flicker open and shut, called chattering; hold and hysteresis cure it.

Using a gate

  1. Solo the track and play the quietest passage you want to keep.
  2. Lower the threshold until those notes open the gate cleanly, then raise it until the noise in the gaps no longer does.
  3. Set the release by ear, so each note dies away naturally.
  4. Check it in the full mix, not only on solo.

Many gates can filter their detector (sidechain) so that, say, the kick drum bleeding into a snare microphone no longer opens the snare's gate. A key input lets another signal open the gate: a kick drum can key a gate on the bass, so a bass note cannot start before the kick. Guitarists using heavy distortion often add a gate pedal, sometimes sold as a noise suppressor (effects pedal). Gating a big reverb on drums gives gated reverb, the huge but abruptly cut-off snare sound associated with much 1980s pop.

Gate, expander or compressor?

A compressor turns down what rises above its threshold; a gate acts on what falls below it. A downward expander works on the same quiet side, but gradually: it turns low signals down in proportion to a ratio. A gate is in effect an expander with an infinite ratio, dropping everything below the threshold by a fixed amount. The gate setting of an arpeggiator or step sequencer is something else again: there it means how long each note is held.

Common questions

What does a noise gate do?

It turns a signal down or off whenever its level drops below the threshold, so the hum, hiss or spill in the pauses disappears. It cannot remove noise that sounds at the same time as the music.

What is the difference between a noise gate and an expander?

Both turn down signals below a threshold. An expander does it gradually, by a ratio, so quieter sounds are reduced more; a gate drops everything below the threshold by a fixed amount, which may be full muting.

Why does my noise gate cut off the ends of notes?

The threshold is probably too high or the release too short. Lower the threshold, lengthen the hold or release, or set the range to turn the signal down rather than off.

Was this entry helpful?

Comments