Music Production
Distortion
Distortion is any change to a sound's waveform that adds new frequencies. Used on purpose, as saturation, overdrive or fuzz, it makes a guitar or other sound grittier and richer; when unwanted, it is a fault.
In audio, distortion is what happens when a device does not pass a signal through faithfully: the shape of the waveform changes, and new frequencies appear that were not in the original. It usually comes from pushing a signal harder than a circuit can handle cleanly. Designers of amplifiers, microphones and converters try to keep it low, and equipment specifications quote it as total harmonic distortion (THD). Musicians, on the other hand, often add it on purpose.
How it adds harmonics
Drive a pure sine wave too hard and its peaks flatten. The flattened wave has gained overtones: the harder it is clipped, the closer it comes to a square wave. Distortion that treats the top and bottom of the wave alike adds mainly odd-numbered harmonics. Asymmetric distortion, which treats them differently, adds even-numbered harmonics as well and tends to sound fuller. When the new frequencies are harmonics of the note being played, the result can sound rich rather than broken.
Hard and soft clipping
- Hard clipping cuts the peaks off abruptly at a fixed level. It sounds harsh and buzzy.
- Soft clipping bends the wave more gradually as it nears the limit, so some distortion begins before the peaks are flattened. It sounds smoother and is more typical of analog circuits.
Unwanted overload at a converter or in a digital file is covered in clipping.
Saturation, overdrive, fuzz
These names describe degrees and flavors rather than strict categories, and people use them loosely:
- Saturation is the subtle end: a gentle thickening, as when tape, tubes or transformers are pushed a little. It is used in mixing on single tracks or across a whole bus.
- Overdrive is a moderate grit, originally the sound of a tube guitar amplifier turned up loud.
- Distortion, in the guitar-pedal sense, is heavier and denser.
- Fuzz is the extreme end, buzzy and close to a square wave.
Using it
On an electric guitar, distortion usually comes from the amplifier, most often its preamp gain, or from pedals placed before the amp. When several notes are distorted together they also produce new frequencies between them that belong to none of the notes, so heavy distortion can make full chords sound muddy; that is one reason two-note power chords are so common in rock. In production, distortion also works on synths, drums and vocals. A little saturation added to the upper range of a deep bass line can help it be heard on small speakers that cannot reproduce its lowest notes.
A common confusion
Distortion is not the same as loudness. A distorted guitar turned down to a whisper at the speaker is still distorted, and a clean sound can be very loud. Turning down later does not remove distortion created earlier in the chain, so set clean levels where you do not want it (headroom).
Common questions
What is the difference between overdrive and distortion?
Mostly degree. Overdrive usually means a milder, smoother grit, like a tube amp pushed hard; distortion means a heavier, denser sound. The names are used loosely, and pedals sold under either name overlap.
Is distortion the same as clipping?
Clipping, flattening a signal's peaks, is one of the most common ways to create distortion, but not the only one. Distortion is the wider term for any change to the waveform that adds new frequencies, wanted or not.
Comments