Skip to main content

Music Production

Clipping

Definition

Clipping is distortion caused when a signal exceeds the level a stage can pass or represent, restricting its waveform peaks. It can happen in analog equipment, converters or digital processing, not only at the final output.

Imagine a waveform trying to rise beyond a circuit's available output. Its peak cannot continue as intended. Hard clipping cuts peaks abruptly; soft clipping rounds the transition more gradually. Both change the waveform and its sound. Producers sometimes use that distortion deliberately, but unwanted overload can spoil a recording.

Where the limit is

For ordinary fixed-point digital audio, 0 dBFS marks full scale. Values beyond the representable range cannot be stored faithfully. Analog microphones, preamps and converters also have limits, even when a later DAW meter looks low.

Floating-point processing and files can represent levels above 0 dBFS without those values necessarily being clipped. That does not make the entire recording chain overload-proof: an earlier analog stage or a level-sensitive plug-in can already have distorted. Reduce intact floating-point levels before sending them to a fixed-point export or output that cannot accommodate them.

Turning down is not the same as repairing

A fader after an already clipped stage makes its damaged waveform quieter; it does not restore the missing peaks. De-clipping software can estimate replacements, with results that depend on the damage. It cannot guarantee the original waveform. Re-recording a clean take may be preferable.

Check the first overloaded stage

Start with the source and input, then inspect each processor and the output. Leave headroom before an unpredictable performance or a level boost. If a clip light appears, check what that meter measures rather than assuming every red indicator describes the same event. A sample-peak meter also does not reveal every peak between samples; true-peak metering estimates the reconstructed waveform's peaks. These checks complement careful listening at a moderate level.

Common questions

Does 32-bit float repair a clipped microphone or preamp?

No. It can preserve large digital values that are still intact, but it cannot undo distortion already created before those values were stored.

Can a quiet recording still be clipped?

Yes. A signal may have clipped earlier and then been turned down. Its current peak level alone does not prove that its waveform is undamaged.