Music Production
Flanger
A flanger is an audio effect that mixes a sound with a copy delayed by a few milliseconds and sweeps that delay up and down. The result is a moving comb filter, heard as a whooshing, jet-like sweep.
Mix any sound with a copy of itself delayed by a few milliseconds, and some frequencies arrive in step and reinforce while others arrive exactly out of step and cancel (phase). The result is a comb filter: a long row of evenly spaced notches and peaks across the spectrum. A 1 ms delay puts the first notch at 500 Hz and further notches every 1,000 Hz above it, at 1,500 Hz, 2,500 Hz and so on. A longer delay moves the notches lower and closer together.
A flanger sweeps that delay time up and down with an LFO, so the whole comb glides through the spectrum: the familiar whoosh. Feedback, sending part of the output back into the delay, sharpens the peaks until the sweep becomes a ringing, metallic whine.
The controls
- Delay (on some units, manual): the starting delay time, and so where the comb sits.
- Rate and depth: how fast and how far the LFO sweeps the delay.
- Feedback (or resonance): how intense and metallic the sweep becomes.
- Mix: an even balance of the dry and delayed sounds gives the deepest notches.
With the LFO switched off, a flanger becomes a fixed comb filter, a metallic, ringing coloration that can suit a drum loop or a rhythm part.
Tape flanging
The effect began as a studio trick with tape. Engineers played the same recording on two tape machines at once, mixed their outputs, and slowed one of them slightly by pressing a finger on the flange, the rim, of its tape reel. Because either machine could fall behind the other, the delay between them passed through zero, which gives tape flanging its deep, dramatic sweep. Many modern flangers cannot do this; those that can are called through-zero flangers. The drum fills of the Small Faces' "Itchycoo Park" are a much-cited example of the tape effect.
Using it
Flanging is most obvious on harmonically rich sounds: distorted guitar, synths, cymbals and drum loops. Heavy flanging can sound dated, so many producers use it briefly, on a fill, a transition or a single word, or place it before a reverb on a send, where it colors the reverb rather than the dry part.
Flanger, chorus and phaser
- A chorus uses a somewhat longer delay, often without feedback, for a gentle thickening shimmer rather than a sweep.
- A phaser uses phase-shifting filters instead of a delay. It makes only a few notches, not evenly spaced, so it sounds less like a comb.
- A fixed short delay with no sweep thickens or doubles a part; a long one is an echo (delay).
Common questions
What is the difference between a flanger and a phaser?
A flanger mixes in a short, swept delay, which creates many evenly spaced notches across the spectrum, a comb filter. A phaser uses all-pass filters instead of a delay and creates only a few notches that are not evenly spaced.
What does the feedback knob on a flanger do?
It sends part of the output back into the delay, which deepens and sharpens the comb filter's peaks. Turned up, the sweep becomes a strong, ringing whine.
Comments