Skip to main content

Music Production

Chorus (Effect)

Definition

Chorus is an audio effect that mixes a sound with a slightly delayed copy whose delay time keeps changing, so the copy drifts a little in pitch and timing. The blend sounds thicker and wider, like several players at once.

When several singers or violinists play the same line, they are never exactly together: each is a little early or late, and a fraction out of tune with the others. The chorus effect imitates that blur. It copies the incoming sound, delays the copy by a short time, and keeps varying that delay with a slow LFO. As the delay grows and shrinks, the copy's pitch bends slightly up and down. Mixed back with the original, the two drift against each other and the sound shimmers.

The controls

  • Rate: the speed of the LFO, from a slow swirl to a fast warble.
  • Depth: how far the delay time moves, and so how much the pitch wavers.
  • Mix (wet/dry): the balance between the original and the moving copy. With no dry sound at all, you hear only the pitch wobble, which is vibrato rather than chorus.
  • Delay time, feedback and width on some units. Stereo choruses often treat the left and right sides differently, so the sound also spreads across the stereo field.

Where you hear it

Chorus thickens clean electric guitar, electric piano, fretless bass, synth pads and backing vocals. It was used very widely from the 1970s into the early 1990s, then fell out of fashion for a time, and it has come back into use more recently. Roland's JC-120 Jazz Chorus amplifier (1975) had a built-in stereo chorus, and the BOSS CE-1 Chorus Ensemble put that kind of effect in a floor unit the following year (effects pedal). An ensemble effect runs several chorus voices at different rates at once, for a smoother, lusher result; early string machines used chorusing to make one basic tone sound like a string section.

Using it

Start with a slow rate, a modest depth and the mix around halfway, then adjust by ear. On a bass part, keep the low end dry and let only the upper frequencies of the chorus through, so the bass stays solid. A chorus on an effects send, placed before a reverb, adds movement more subtly than one on the track itself.

Chorus, flanger and phaser

A flanger uses an even shorter delay, often with feedback, and produces a sweeping whoosh rather than a shimmer. A phaser sweeps a few notches through the sound using phase-shifting filters instead of a delay. Longer, unmodulated delays become echoes (delay).

A common confusion

The effect has nothing to do with the chorus of a song, the section with the hook. When a chart or a forum post says "add chorus", it means this effect; when a lyric sheet says "Chorus", it means the section.

Common questions

What does a chorus pedal do?

It blends your signal with a copy whose delay time is slowly and continuously varied, so the copy wavers slightly in pitch. The result sounds thicker, wider and shimmering, as if more than one instrument were playing.

What is the difference between chorus and flanger?

Both mix a sound with a delayed copy whose delay keeps changing. A flanger uses shorter delays and often feedback, which gives a strong sweeping whoosh; chorus uses a somewhat longer delay for a gentler, thickening shimmer.

Was this entry helpful?

Comments