Music Production
Send and Return
A send routes an adjustable amount of a channel's signal to another path. A return brings the resulting signal into the mix, often after a shared effect such as reverb or delay.
A typical send-and-return setup adds an effect alongside the original sound. The source keeps its main output, while a send branches off to an auxiliary bus. A return channel receives that path, hosts an effect and feeds the mix. Several instruments can share the same reverb while sending different amounts to it.
Parallel versus insert processing
An insert sits in the channel's own processing chain. A send creates another route. For an ordinary shared reverb, set the effect on the return to 100% wet, then balance the return against the original channels. Otherwise the return can add another dry copy as well as reverb. This is a common starting point, not a rule for every parallel effect.
A send does not inherently remove the source from its main output. Some DAWs offer a sends-only output choice when you deliberately want no direct route to the mix.
Pre-fader and post-fader
A pre-fader send is tapped before the source channel's level fader, so moving that fader does not change the send level. This helps create an independent headphone mix. A post-fader send follows that fader, which often suits effects that should follow a track's level changes.
Pre-fader does not automatically mean pre-EQ or pre-effects. The exact tap point, pan behavior and mute behavior depend on the mixer and its settings.
Trace it before changing it
Sketch a dry vocal route and a separate reverb route. Label the send knob, effect and return fader. The send adjusts that vocal's contribution; the return fader changes the shared result. Avoid accidental feedback routes, and check both paths for clipping before increasing levels.
Common questions
Why use a return instead of one reverb on every track?
Several tracks can share one effect and a common acoustic space, with separate send amounts. Inserts are still useful when a track needs its own treatment.
Does pre-fader mean unprocessed?
No. It only identifies the tap relative to the channel fader. EQ or other effects may already have processed the signal; check the mixer or DAW's routing.