Music Production
Microphone
A microphone turns sound waves into an electrical signal that can be recorded or amplified. The main kinds, dynamic, condenser and ribbon microphones, differ in how they work, how they sound and whether they need power.
A microphone is a transducer: it turns one kind of energy into another. Sound makes a thin diaphragm move back and forth, and the microphone turns that motion into a matching electrical signal. The signal is very small, so it first goes to a preamp, set with the gain control of an audio interface or mixer, before it is recorded in a DAW or sent to speakers.
Three main types
- Dynamic (moving-coil): a coil of wire fixed to the diaphragm moves in a magnet's field and generates the signal; the element is built much like a small loudspeaker. Dynamic mics are rugged, handle very loud sources without distorting and need no power, which makes them a common choice on stage and for loud sources such as guitar amps and drums.
- Condenser: a thin diaphragm sits close to an electrically charged backplate. As it vibrates, the spacing between the two changes and creates the signal. The light diaphragm follows quiet detail and high frequencies easily, which suits acoustic guitar, strings and cymbals. A condenser needs power, from a battery or, more often, as phantom power sent up the cable from the interface or mixer (usually 48 volts; many mics also work on less).
- Ribbon: a kind of dynamic mic in which a very thin strip of metal, typically corrugated aluminum, hangs between the poles of a magnet. Ribbons are valued in the studio for a smooth, warm sound. Their output is usually low, so they need plenty of clean gain. The ribbon is delicate: a blast of air can stretch it, and phantom power can harm some models, so check the manual first.
XLR and USB
Most stage and studio microphones send an analog signal down a three-pin XLR cable to an interface or mixer. A USB microphone has a converter built in that turns the sound into digital audio, so it plugs straight into a computer. It is simpler to set up; XLR mics with a separate interface are more flexible.
Direction and distance
Microphones also differ in which directions they hear best, their polar pattern:
- A cardioid mic picks up mostly from the front and least from behind, which helps keep other instruments and stage speakers out.
- An omnidirectional mic hears equally all around: open and natural, but it picks up more of the room.
- A figure-8 (bidirectional) mic hears the front and back but not the sides. Most ribbon mics work this way.
Move a directional mic very close to the source and the bass grows, an effect called proximity effect. Backing off, or a low-cut filter (EQ), tames it.
A common mix-up
A more sensitive or more expensive microphone is not automatically the better choice. In a noisy or echoing room, a sensitive condenser can record much of the room too, while a dynamic mic close to the source may give a cleaner take. Choose for the source, the room and the job, and with two or more mics on one instrument, check how they combine (phase).
Common questions
What is the difference between a dynamic and a condenser microphone?
A dynamic mic generates its signal with a coil moving in a magnetic field; it is rugged, handles loud sources and needs no power. A condenser uses a light diaphragm next to a charged backplate; it picks up quiet detail and high frequencies more readily and needs phantom power or a battery.
Do dynamic microphones need phantom power?
No. Moving-coil dynamic mics make their signal without power. Condenser mics need power, most often phantom power. Some ribbon mics can be damaged by it while others need it for built-in electronics, so check the maker's instructions.
Comments