Skip to main content

Music Production

Mixer (Mixing Console)

Definition

A mixer combines several audio signals into one or more outputs, with controls for each channel's level, tone, panning and sends. It can be a hardware mixing console or the mixer window of a DAW.

A mixer takes many inputs, such as microphones, instruments and recorded tracks, adjusts each one and adds them together into a smaller number of outputs: the main stereo mix, plus feeds for headphones, stage monitors and effects. Hardware mixers range from small boxes with a handful of channels to large studio and live-sound consoles, and they may be analog or digital. Almost every DAW has a software mixer laid out in much the same way, so what you learn on one helps with the other.

The channel strip

Each input has its own column of controls, the channel strip. On a typical analog mixer the signal runs roughly from top to bottom, though the exact controls and their order vary from model to model:

  1. Gain (trim): the preamp, which matches the channel's sensitivity to the source. A quiet microphone is amplified and a loud line-level signal turned down. It is usually where most of the amplification happens (gain).
  2. EQ: bass and treble controls or a full parametric EQ. A boost adds level too, and too much can overload the channel, so cutting is often the safer move.
  3. Aux sends: knobs that feed part of the channel to an auxiliary bus for a monitor mix or an effect, taken before or after the fader (send and return).
  4. Pan: places the channel between left and right (panning).
  5. Mute, solo and the fader: the fader is the sliding control that sets the channel's level in the mix.

Many consoles also have an insert point, a socket that routes the channel through an outboard processor such as a compressor and back.

The master section

The channels are summed, added together, on the mix bus, and the master fader sets the level of the main output. Group or subgroup faders control several channels at once, and aux masters set the overall level of each send.

A starting routine

  1. Start with every fader and gain control turned down.
  2. With the source playing as loud as it will get, raise its gain until the peak light starts to flash, then back off a little so that it flickers only now and then.
  3. Set the master fader to its "0" mark.
  4. Bring up the channel faders to build a rough balance, and keep unused channels down to avoid extra noise.

Balancing and shaping the channels from there is mixing.

Gain or fader?

Both change level, but at different points. The gain sets how much signal enters the channel; the fader sets how much of it goes to the mix. If a channel distorts at its input, pulling the fader down will not fix it: turn the gain down instead.

Common questions

What is the difference between a mixer and an audio interface?

A mixer combines and adjusts many signals into a few outputs. An audio interface connects microphones, instruments and speakers to a computer and converts between sound and digital audio. Some products combine the two.

What does a fader do on a mixer?

It sets how much of a channel's signal goes into the mix. Moving faders up and down is how you balance the parts; the gain control at the top of the strip sets the level coming in.

Was this entry helpful?

Comments